| Cheshire Cat Computing http://www.steveshipway.org/forum/ |
|
| Summary target not displayed for Device? http://www.steveshipway.org/forum/viewtopic.php?f=15&t=10997 |
Page 1 of 1 |
| Author: | vk2him [ Fri Aug 18, 2017 1:25 pm ] |
| Post subject: | Summary target not displayed for Device? |
I have a weird situation with a UPS device that I've just added - it creates the targets fine for battery voltage, estimated capacity, load watts etc however there is no summary target which means I have to click on every target to view it's graph. Is there a way to "force" every target to display, which seems to be what the summary does? |
|
| Author: | stevesh [ Wed Aug 23, 2017 4:47 pm ] |
| Post subject: | Re: Summary target not displayed for Device? |
If you post the config here I could verify, but the reason is probably that none of the Targets were added to the Summary , so the summary was empty, so it is not displayed. To fix this, add routers.cgi*InSummary[_]: yes to the start of the configuration. This will make all Targets appear in the summary regardless of the default. |
|
| Author: | vk2him [ Wed Aug 23, 2017 10:45 pm ] |
| Post subject: | Re: Summary target not displayed for Device? |
| Page 1 of 1 | All times are UTC + 12 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|