| Cheshire Cat Computing http://www.steveshipway.org/forum/ |
|
| Removing Totals and MaxByte from user defined graphs http://www.steveshipway.org/forum/viewtopic.php?f=15&t=4060 |
Page 1 of 1 |
| Author: | calivw78 [ Mon Dec 07, 2009 7:30 am ] |
| Post subject: | Removing Totals and MaxByte from user defined graphs |
Any way to remove the Totals from the graph? Also, I would like the MaxByte value to not be apparent in the graph. Meaning, I would like the highest value on the Y axis to be represented by the highest value polled, as opposed to what the maxbyte is set to. I tried a few things with both my .cfg and routers2 config but no luck. Although it doesn't bother me as much, it would be even better if only the current value was displayed, though that is not as big of a deal. Any thoughts? Thanks in advance. Here is where I am at so far... |
|
| Author: | calivw78 [ Mon Dec 07, 2009 7:33 am ] |
| Post subject: | Re: Removing Totals and MaxByte from user defined graphs |
I should clarify. By "Current value" I meant down in the legend. |
|
| Author: | stevesh [ Tue Dec 08, 2009 10:56 am ] |
| Post subject: | Re: Removing Totals and MaxByte from user defined graphs |
Routers.cgi*Options[xxxx]: nomax This gets rid of the MaxBytes line, Routers.cgi*Options[xxxx]: nototal This gets rid of the calculated total in the text block. You only get a Total line in the graph (as above) if you have specified 'total' in the routers.cgi*Graph[] definition on one of the component targets. Make sure you dont have 'total' or 'average' in the component routers.cgi*Graph lines and it should be OK. If you still have problems, post your CFG file contents here so I can check it. |
|
| Page 1 of 1 | All times are UTC + 12 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|