Cheshire Cat Computing

I have a weird situation with a UPS device that I've just added - it creates the targets fine for battery voltage, estimated capacity, load watts etc however there is no summary target which means I have to click on every target to view it's graph. Is there a way to "force" every target to display, which seems to be what the summary does?

_________________
[img]http://wx.theshackbythebeach.com/wx/wxgraphic.php?type=banner_big[/img]
[url]http://wx.theshackbythebeach.com/wx/wxindex.php[/url]

If you post the config here I could verify, but the reason is probably that none of the Targets were added to the Summary , so the summary was empty, so it is not displayed.

To fix this, add

routers.cgi*InSummary[_]: yes

to the start of the configuration. This will make all Targets appear in the summary regardless of the default.

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11

_________________
[img]http://wx.theshackbythebeach.com/wx/wxgraphic.php?type=banner_big[/img]
[url]http://wx.theshackbythebeach.com/wx/wxindex.php[/url]