Steve:
- Does RoutersUptime[] work with Routers2cgi Windows IIS Conbination ?
- Does Routers2.cgi Supports RouterUptime[] ? If Not do you have a workaround ??
Thank you very Much
Toronto, Canada (
)
| Cheshire Cat Computing http://www.steveshipway.org/forum/ |
|
| RouterUptime[] http://www.steveshipway.org/forum/viewtopic.php?f=2&t=1154 |
Page 1 of 1 |
| Author: | zoemu [ Thu Jun 28, 2007 4:36 am ] |
| Post subject: | RouterUptime[] |
Steve: - Does RoutersUptime[] work with Routers2cgi Windows IIS Conbination ? - Does Routers2.cgi Supports RouterUptime[] ? If Not do you have a workaround ?? Thank you very Much Toronto, Canada ( )
|
|
| Author: | stevesh [ Thu Jun 28, 2007 10:31 am ] |
| Post subject: | |
routers2 does not support RouterUptime[]. The reason for this is that, to prevent lockups eand to speed performance, no SNMP lookups are made at run-time (except by some plugins) and so this cannot be calculated. If a device is down, it could cause some long waits to display the page. Also, RouterUptime[] is a relatively new MRTG directive. The wishlist does contain an item to support this as a (usually disabled) option, so people who want it can have it. It is not expected to make v2.18 though unless I get a lot of people asking for it (so far, you are only the second). |
|
| Author: | zoemu [ Fri Jun 29, 2007 2:19 am ] |
| Post subject: | RouterUptime[] |
Steve: Thank you for your response. I better start campaigning (  )
Luis Alegria. Toronto Canada. |
|
| Page 1 of 1 | All times are UTC + 12 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|