Cheshire Cat Computing

Instead of this:

routers.cgi*Graph[$target_name]: All-Errors active

put this:

routers.cgi*Graph[$target_name]: All-Errors-in active noo
routers.cgi*Graph[$target_name]: All-Errors-out active noi

This creates two userdefined graphs, one holding the incoming errors and one the outgoing errors. You might also like to add some customisations for the labelling.

routers.cgi*ShortDesc[All-Errors-in]: Incoming Errors
routers.cgi*Title[All-Errors-in]: Incoming Errors for my router

... and so on.

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11

Steve,

Hey thanks for the reply.

Oh good idea...! I didn't think to go that route of using a UserDefined Graph.
I'm assuming that Routers2 recognizes what "Unit" your using and if it's for Traffic then it automatically creates the Incoming and Outgoing graphs.

Thanks again and good idea!
Matt