Cheshire Cat Computing

Hi:

I need 1 min resolution graph for 24 hours instead of 6 hours.
Is it possible.

Thank you

/Jin

No, it is not possible. For a start, your screen does not have a high enought pixel resolution to hold the graph image (at one pixel per data point).

The daily graph is 400 pixels wide because there are 400 data points at 5-min resolution (the actual width is higher because of axis, padding, and so on). That is why you get 6-hour for a 1-min interval. Also, depending on your RRDTool/MRTG setup, you may not have afull 24hr worth of 1-min resolution data before it is rolled up to the 5-min interval.

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11

The current version does allow you do do a double-datawidth graph, if your screen is large enough. Therefore you can get 12 hours at 1-min resolution, which results in a graph large enough to require a 1024x768 screen resolution.

This is about half of what you're asking for. However, I can't enable a general 4xdatawidth graph, since only the 6-hour-capable RRDs would be able to support it.

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11