Cheshire Cat Computing

I was hoping that "routers.cgi*LowerLimit[...name...]: 1000" would help when the graph is really a HUGELY negative . Like this graph mo-rtr01.cfg-_mo-rtr01_1I-IE-m-x2.png :-} .
Tia , JimL

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11

routers.cgi*LowerLimit[]: -200000
routers.cgi*UpperLimit[]: 512000
routers.cgi*Options[]: rigid

I started placing these line at the Combined graph (ie: mo-rtr01_1I-IE) and the graphic is 'trimmed' at the very bottom of it's lowest point , But not at my selected cutoff value . I then proceded to set them at each level above that , with the same effect .
ie: at the mo-rtr01_1 , mo-rtr01_1IE config points .
Heck I have even tried setting the cutoff value to -1 . With no other effect to the graphic than the trimming mentioned previously .

Tia , JimL

Hmm, this doesnt sound quite right.

I have to admit I've not really done any testing with negative factors and so its quite possible this is borken. The LowerLimit does work with positive values (this is tested) but with a negative factor it seems all bets are off, I'll need to do more investigation

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11