Cheshire Cat Computing

Any way to remove the Totals from the graph? Also, I would like the MaxByte value to not be apparent in the graph. Meaning, I would like the highest value on the Y axis to be represented by the highest value polled, as opposed to what the maxbyte is set to. I tried a few things with both my .cfg and routers2 config but no luck. Although it doesn't bother me as much, it would be even better if only the current value was displayed, though that is not as big of a deal. Any thoughts? Thanks in advance.

Here is where I am at so far...

I should clarify. By "Current value" I meant down in the legend.

Routers.cgi*Options[xxxx]: nomax

This gets rid of the MaxBytes line,

Routers.cgi*Options[xxxx]: nototal

This gets rid of the calculated total in the text block.

You only get a Total line in the graph (as above) if you have specified 'total' in the routers.cgi*Graph[] definition on one of the component targets. Make sure you dont have 'total' or 'average' in the component routers.cgi*Graph lines and it should be OK.

If you still have problems, post your CFG file contents here so I can check it.

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11