I must not understand the layout of the cfg file. I am still having trouble graphing the CPU utilization for our Nortel routers.
I read through your answer to my first post and what I did was opened an existing cfg file and added the lines you discussed. But now I can not get anything to display for this one target, including the serial line utilization. The error message I keep getting is can't read the rrd file in \mrtg\wwrorrt\
This is what my cfg file looks like now......
my procedure for adding the lines was, first I added the lines and then I ran the newcfg.bat file with the update cfg file. after that everything stopped for this target.
One other question I have come across is with the OID's I a m using.
1.3.6.1.4.1.18.3.3.2.5.7.1.2.1
1.3.6.1.4.1.18.3.3.2.5.7.1.4.1
The .1 at the end of the OID's was added by me because I thought I needed to add the instance ID at the end. Could this be what is causing the graph to stop?
### Interface 2 >> Descr: 'Frame Relay' | Name: 'DHEC.598300' | Ip: '10.23.1.42' | Eth: '' ###
Target[10.31.52.253_2]: 2:public@10.31.52.253:
SetEnv[10.31.52.253_2]: MRTG_INT_IP="10.23.1.42" MRTG_INT_DESCR="FR DHEC.598300"
MaxBytes[10.31.52.253_2]: 96000
Title[10.31.52.253_2]: Traffic Analysis West Des Moines FR Circuit DHEC.598300
PageTop[10.31.52.253_2]: <H1>Traffic Analysis West Des Moines Circuit DHEC.598300 </H1>
<TABLE>
<TR><TD>System:</TD> <TD>West Des Moines Family Practice</TD></TR>
<TR><TD>Maintainer:</TD> <TD>IHS Networking</TD></TR>
<TR><TD>Description:</TD><TD>FR Circuit DHEC.598300</TD></TR>
<TR><TD>ifType:</TD> <TD>frame-relay (32)</TD></TR>
<TR><TD>ifName:</TD> <TD></TD>West Des Moines Relay FR Circuit DHEC.598300</TR>
<TR><TD>Max Speed:</TD> <TD>768.0 kbits/s</TD></TR>
<TR><TD>Ip:</TD> <TD>10.23.1.42</TD></TR>
</TABLE>
###### This section was added to try and graph CPU utilization ####
Target[10.31.52.253]: 1.3.6.1.4.1.18.3.3.2.5.7.1.2.1&1.3.6.1.4.1.18.3.3.2.5.7.1.4.1:public@10.31.52.253
routers2.cgi*Options[10.31.52.253]: dorelpercent
MaxBytes[10.31.52.253]: 999999999999
Legand[10.31.52.253]: usage:
Legend1:[10.31.52.253]: CPU percent used
Legend3[10.31.52.253]: Peak CPU percentage Used
Any insight as to where I have made mistakes would be greatly appreciated.
Login
Register
FAQ
Members
